4-20 | Model 933S UV Analyzer
• Click NO if you want the parameter changes to be valid only for the
current session (temporary changes). The changes will revert to the
previously saved changes after the system is powered down and then
powered up again, or if the analyzer is reset.
• You can change numerous parameter values on multiple setup screens
before clicking Apply or saving the new value(s) to the analyzer’s
EEPROM.
• When you make configuration or calibration changes, the Refresh
button on the Setup tab will flash to indicate that changes have been
made. When you click this button, the software polls the parameters
and updates the changes in the software.
• On individual setup screens, click Refresh to change the values back
to their original settings (the values that were last saved to the sys-
tem’s EEPROM). Changes can only be refreshed if the Apply button
has not been pressed, or if the Save CFG to EEPROM button (Setup
tab) has not been pressed.
• To change parameters only for the current session, do not click Save
CFG to EEPROM. The changes will revert to the previously saved
changes after the system is powered down and then powered up
again, or if the analyzer is reset.
• You can make changes to multiple Modify Configuration dialog boxes
before clicking Save CFG to EEPROM.
To Next Page
Loading...
Need help?
General
