3.6.5. Check air lter vacuum valve
Any dust trapped will automatically be emptied during Ma-•
chine operation. We recommend to occasionally clean the
exit slit, press to remove any dust trapped.
Should the Machine be tted with air pre cleaner, clean the •
vessel (1) when lled with dirt up to the mark, rst unscrew
nut (2) and remove cover (3).
Do NOT operate the Machine when dust
valve is damaged.
3.6.6. Hydraulic tank oil level check
Open oil tank cover. Check and maintain oil level. Pilot lamp •
will indicate any oil loss below STOP (engine stops).
! CAUTION !
Engine can be started only after oil is lled up. Fill
up with the same type of oil via lling device, refer
to Section called “Oil Exchange“.
To Next Page
Loading...
