After 2,000 hours of operation (after 2 years)
3.6.28. Check, adjust valve clearance
Please, contact your regional CUMMINS representatives, •
refer to “Engine Operation And Maintenance Manual” (sup-
plied with the Machine), or your dealer.
3.6.29. How to exchange oil in rear axle
Clean and remove drain plugs (1), lling plugs (2) – in both •
housings. With oil drained, install plugs (1) and pour 5,2 l
(1,4 gal US) amount through the holes into each housing as
per Section 3.2.6., close with plugs. Oil may ow out slightly
from holes (2).
Observe re precautions!
Use recommended oils only, as per
Section. 3.2.6.
Drain oil when operation has ended after
cooling down to 50 °C, or while driving
the Machine, wait until oil warms up.
Exchange oil rst after 250 hours of op-
eration of new Machine or after Major
Overhaul.
Beware of burn hazard when draining
hot oil.
Drain oil into collection vessel of 6 l (1.6
gal US) capacity.
Spent oil is ecological waste – hand over
for disposal.
To Next Page
Loading...
