Ammann AP 240 - Check Alarm and Control Instruments

104 AP 240
I
II
III
IV
0
374056
I
I
II
III
IV
0
P
0
START
START
START
3236
3236
1
2
3
F
R
N
374057
2000
ENG RPM
50°C
COOL TEMP
100
ENG HRS
1 bar
OIL PRESS
I
II
III
IV
0
P
0
START
START
START
3236
3236
374058
II
374059
1
2
3
F
R
N
3.6. Lubrication and Maintenance Operations
3.6.11. Check alarm and control instruments
Turn ON the switches to test that lights, warning lamps, traf-•
c indicator lights, ashing beacon.
Turn ignition key to position ”I” (conrm travel controllers •
are in idle position [neutral], parking brake switched ON),
pilot lamps for recharging, idle position, parking brake must
light up. Check Power View display and horn.
Start the engine, pilot lamp for recharging must go o, •
check engine oil pressure via the display. Press TOTAL STOP
button – engine will stall.
Start the machine according to the respective instructions in •
the Operating Manual. When turning o the parking brake
switch, make sure that the brake pilot lamp turns o. When
driving o, make sure that the respective pilot lamp of the
activated place turns on and whether the neutral pilot lamp
turns o.