Ammann AP 240 - Oil - Epicyclic Transmission Incl. Torque Converter; Gear Oil; Brake Fluid; Lube Grease

92 AP 240
0787
2260
2186
2186
3.2. Media Specification
3.2.8. Lube Grease
Use plastic lubricant with lithium content to lubricate the Ma-
chine under the following standards:
ISO 6743/9 CCEB2
DIN 51502 KP2K-30
When hazard of temperature drop below
0 °C (32 °F) exists then add antifreeze
agent or drain water!
3.2.9. Windscreen Sprayer Liquid
Use clean water up to 0 °C (32 °F) temperature when lling the
windscreen sprayer tank. We recommend to use water with
washing, antifreeze agent for motor vehicle windscreen sprayers
at the ratio as per the Machine lubricating conditions – in CR it
is Glacidet K.
3.2.6. Gear Oil
Use SAE 80W-90H API GL 5 or MIL-L-2105 B/C / LS oils to lubri-
cate hypoid nal drive.
Use SAE 80W-90H API GL 5 or MIL-L-2105 B/C / LS oils to lubri-
cate down gearings.
3.2.7. Brake Fluid
The uid should comply with international specication of ISO
4925, SAE J 1703 f, DOT 3. It is miscible with brake uids of all
brands that correspond with these specications. Brake uid is
designed for brake systems that operate at ambient tempera-
tures from –50 °C (–58 °F) to 60 °C (140 °F) and at operating tem-
perature from –50 °C (–58 °F) to 205 °C (400 °F).
Note:
As for the brake system, you may also use brake uid that cor-
responds to international classication of DOT 4.
3.2.5. Oil – epicyclic transmission incl.
torque converter
Gearbox can be lled alternatively with the following oils:
Mogul ATF II
Caterpillar TO-4
John Deere J20 C,D
Military MIL-PRF-2104G
Allison C-4
General Motors Dexron II Equivalent
! CAUTION !
NEVER use engine oils, transmission oils or DEXRON
III.
With normal ambient temperature, please use mul-
ti-grade oil of low viscosity value 10W – 20 as if low-
grade oil 10W was used. If you use oil C-4 instead
of J20 then viscosity range not exceeding 10W, i.e.
10W – 20, is recommended. Use J20C, D oil during
extensive uctuation in temperatures.
Synthetic oil has been approved to be used for
gearboxes if it corresponds to the abovementioned
specications.
Concerning ambient temperature characterized as
TROPIC we recommend to use oil of SAE 30 viscosity
value that corresponds to the Caterpillar TO-4 per-
formance classication.