After 250 hours of operation (3 months)
3.6.13. How to exchange oil in engine
Drain oil when it is still hot after opera-
tion is ended, or while running, warm up
the engine until cooling liquid reaches
60 °C.
Observe re precautions!
Beware of hot oil burn hazard when
draining oil. Let oil cool down below
50 °C.
Remove drain plug and let oil ow out into a vessel of ca 9 l •
(9,5 qt) capacity. Reinstall drain plug. Apply 80 Nm (59 lb ft)
torque to tighten.
Clean oil lter and its vicinity. Remove lter.•
Apply oil slightly across lter gasket.•
To Next Page
Loading...
