3.6. Lubrication and Maintenance Operations
Clean contact surface for lter gasket. Screw on the lter •
and tighten properly with hand.
Use ller neck to ll the engine – medium amount is 7 l •
(7.4 qt).
Fill to upper gauge line of the dipstick. Amount of oil be-•
tween gauge marks on the dipstick is 1,5 l (1.6 qt).
Drain oil into catch vessels.
Spent oil and lter are ecological waste –
hand over for disposal.
Do not tighten excessively the lter, its
thread and gasket may get damaged.
Note:
Refer to Engine Operation and Maintenance Manual for the spe-
cial spanner required.
When exchanged, start the engine for 2 - 3 min. Check tight-•
ness of drain plug and lter. Stop the engine and wait for
5 min. until oil ows down to crankcase sump. Then use dip-
stick to conrm oil level.
Exchange oil after 3 months at the latest
even though 250 hours have not been
actually operated. Exchange oil within
interval that occurs as rst.
Use recommended lters, refer to
Catalogue of Spare Parts.
Use oil as per Section 3.2.1.
To Next Page
Loading...
