3.6.25. How to exchange CLARK gearbox oil
Remove plug, drain oil to a prepared vessel of 21,5 l (5,7 gal •
US) and at the same time replace lter as per Section named
“How to Replace Filter”.
Open the cover underneath control panel.•
Pour the amount of 21,5 l (5,7 gal US) through a hole after •
having pulled out check dipstick, up to FULL mark. Start the
engine and while idling, check oil level to conrm it reaches
up to ADD mark. With oil warmed up to 82÷93 °C, please
check and ll up to FULL if required.
Drain oil when operation has ended af-
ter cooling down to 50 °C, or while driv-
ing you wait until oil warms up.
Beware of burn hazard when draining
hot oil .
Observe re precautions!
Use recommended oils according to
Section 3.2.5.
Drain oil into collection vessels.
Spent oil is ecological waste – hand over
for disposal.
To Next Page
Loading...
