10 AP 240
Machine description
Pneu tyred roller with a rigid frame with a front steerable iso-
static axle and rear drive axle. Each axle is mounted with four
smooth tyres.
Machine application
The roller is intended for medium and large-sized compaction
works in transport construction (roads and motorways, railways,
airelds) and building construction (industrial zones, etc.).
The roller is suitable for compacting the asphalt mixtures up to a
layer thickness (after compaction) of 120 mm, hydraulically con-
solidated mixtures up to a layer thickness of 150 mm, loam and
clay soils up to a layer thickness of 150 mm, mixed soils up to a
layer thickness of 200 mm, and sand and gravel materials up to
a layer thickness of 250 mm.
The roller is not suitable for the compaction of rockll.
The machine is intended for operation in conditions of the fol-
lowing types according to ČSN IEC 721-2-1 (038900): WT, WDr,
MWDr (i.e. mild, warm dry, hot dry with a limited temperature
range of from -15 °C (5 °F) to +45 °C (113 °F).
The standard type of the machine is not intended for road traf-
c. For more information, please contact your dealer.
1.1. Basic Data
Please ll in the following data:
(see Pin label, Label of the CUMMINS engine)
Type of machine
................................................................................................................
ICV/PIN (Serial number of the machine)
................................................................................................................
Production year
................................................................................................................
Type of engine
................................................................................................................
Serial number of the engine
................................................................................................................
Please refer to the data in the table below always when ap-
proaching the dealer or the manufacturer.
To Next Page
Loading...
