Firmware Pages and Descriptions
107
Modero VG Series Touch Panels - Instruction Manual
Information icon
Clicking on the Information icon in the Default Panel Sounds section opens the following window (FIG. 106):
Protected Setup Page
This button opens the Protected Setup page which centers around the properties used by the panel to properly communicate with
the NetLinx Master. Refer to both the Protected Setup Navigation Buttons section on page 116 and the Protected Setup
Page section on page 117 for more detailed information.
Video Slide-Out Menu
Pressing the on-screen Video button causes an option menu to slide outwards from the Navigation buttons (FIG. 107). This option
menu provides you with three choices: Video Adjustment, RGB Adjustment, and Streaming Adjustment. Each of these options
corresponds to an on-board slot position where the related components reside (as seen below). As an example: pass-thru can only be
enabled via slot 2 because the information is routed through the NXA-RGB card residing in Slot 2 on the board. If the panel does
not have the related components, the option menu button will be greyed out. Refer to the following sections for detailed
information on each option.
Video Settings Page
The Video Adjustment page (FIG. 108) (accessed by pressing the Video Adjustment button on the Setup page and then selecting the
appropriate button from the option bar) sets the Video properties of the incoming video signal from an NXA-AVB/RGB Breakout
Box.
FIG. 106
Information icon window
FIG. 107 Video Adjustment Slide-Out Options Bar
FIG. 108 Video Adjustment page (showing default values)
Incoming Video signal
Once done making your screen
adjustments, SAVE SETTINGS.
To Next Page
Loading...
