AMX NXD-1700VG - Step 3: Install the New RGB Card Component (NXD); Step 4: Install the New Compact Flash Memory Card (NXD); Step 5: Close and Resecure the NXD Panel Enclosure

Touch Panel Accessories
38
Modero VG Series Touch Panels - Instruction Manual
Step 3: Install the new RGB Card Component (NXD)
1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the RGB card’s slot connector on the main board and align it with its counterpart on the bottom of the NXA-RGB card.
3. Carefully, but firmly, insert the NXA-RGB card into the RGB connector slot on the main board until both the card rests atop the
four raised securing holes and the RGB RJ-45 connector is evenly aligned with the other RJ-45 connectors on the back of the
panel.
4. Use a grounded Phillips-head screwdriver to secure the four NXA-RGB pan-head securing screws to the raised securing holes
on the main board. Refer to the Step 3: Install the NXA-RGB Card Component (NXT) section on page 35 for more information.
Step 4: Install the new Compact Flash Memory card (NXD)
Complete the procedures outline within Step 4: Install the Compact Flash Memory Card upgrade section on page 36 and then
continue with the following step.
Step 5: Close and Resecure the NXD Panel Enclosure
1. With the components securely installed, gently place the outer housing back onto the metallic panel casing (with the
connector opening on the right-side of the panel) and align the four pan-head Housing Screw holes along the edges of the
outer housing.
NOTE: Use care not to bend or damage any antenna connections while replacing the outer housing.
2. Insert and secure the four pan-head Housing Screws into the pre-drilled holes along the edges of the NXD unit by using a
grounded Phillips-head screwdriver.
3. Remove the previous I/O plate adhesive overlay (this reveals a pre-drilled RGB connector opening) and replace it with the new
adhesive RGB overlay (53-2250-03).
4. Reinstall the upgraded RGB I/O connector plate by aligning all connectors to their respective locations (FIG. 24).
5. Secure the I/O plate using a grounded Phillips-head screwdriver and then twist the Stereo Output nut back onto the Stereo
Output jack.
FIG. 23
Location of the Compact Flash card and I/O plate on NXD
FIG. 24 NXD I/O plate with upgraded RGB overlay
Outer Housing
Compact Flash card
I/O connector
plate
NXA-PCI80211G
wireless card
location
Four Pan-head
Housing
Screws