Touch Panel Accessories
32
Modero VG Series Touch Panels - Instruction Manual
Please follow your particular Wireless Access Point’s instruction manual for the correct procedures to setup either a secured or
unsecured connection.
Product Specifications
FIG. 14 FCC Statement
NXA-PCI80211G Specifications
Dimensions (HWD): • 0.02" x 2.13" x 4.66" (5.0 mm x 54.0 mm x 118.4 mm)
Description: • Direct Sequence Spread Spectrum (DSSS)/CCK 802.11g Wireless mini-PCI card with detachable antennas.
Weight: • 1.05 oz (30g)
Antenna Type: • Dual antenna connector
Bus Interface: • mini-PCI card, TypeIII B
Certifications: • FCCID: CWU-WN2301A, CE, EN 60950, EN 300 328, and RSS 210and FCCID (CWU-WN2301A)
Features: • Contains integrated power amplifier (PA) and low-noise amplifier (LNA)
• Diversity Antenna Connectors automatically select the best available signal
• Enhanced transmit and receive chains
•Field-installable
• Increased sensitivity and multipath tolerance
• Operates from 2.300-2.500 GHz
• Operate at ISM frequency bands (2.4GHz) with 54Mbps data rate
• Pre-configured to communicate with current AMX Wireless Access Points
• Support for IEEE 802.11b and 802.11g
• Wired Equivalent Privacy (WEP) 64-bit and 128-bit data encryption
Frequency Range: • Using 802.11b & g communication:
- 2.412 ~ 2.462 GHz - North America
- 2.412 ~ 2.484 GHz - Japan
- 2.412 ~ 2.472 GHz - Europe ETSI
- 2.457 ~ 2.462 GHz - Spain
- 2.457 ~ 2.472 GHz - France
Media Access Technique: • CSMA/CA with ACK
Modulation: • Orthogonal Frequency Division Multiplexing (OFDM) / Complementary Code Keying (CCK)
Network Architecture: • Ad-hoc mode (Peer-to-Peer)
•Infrastructure mode
Network Standard: • IEEE Compliant
• 802.11b and 802.11g
Operating Channels: • Using 802.11b & g communication:
- 11: (Ch 1 - 11) - North America
- 14: (Ch 1 - 14) - Japan
- 13: (Ch 1 - 13) - Europe ETSI
- 2: (Ch 10 - 11) - Spain
- 4: (Ch 10 - 13) - France
Operating Environment: • Temperature: 0°C ~ 55°C (32°F to 131°F) (operating) and -20°C ~ 70°C (-4°F to 158°F) (storage)
• Humidity: (non-condensing) 5% ~ 90% RH (operating) and (non-condensing) 5% ~ 95% RH (storage)
Operating Voltage: • 3.3V + 5% I/O supply voltage
This device complies with Part 15 of the FCC rules. Subject to the following two conditions:
1. This device must not cause harmful interference and
2. This device must accept all interference, including interference that interferes with the
operation of this device.
Modifications not expressly approved by the manufacturer will void the user’s authority
to operate the equipment.
WARNING: This device has been evaluated and found to be compliant with the FCC Rules
for RF Exposure when the device is operated at a minimum separation distance from the
user and nearby persons. Operation of this device at closer distances should be avoided.
FCC Statement:
Certifications
: FCCID: CWU-WN2301A, CE, EN 60950, EN 300 328,
and RSS 210
To Next Page
Loading...
