Installation Procedures: 12" and 15" Panels
52
Modero VG Series Touch Panels - Instruction Manual
Installing the NXD Into a Flat Surface Using #4 screws
Mounting screws (#4, not included) are secured through circular holes located at the left and right sides of the NXD panel. The
most important thing to remember when mounting the NXD is that the outer frame (Mounting Tabs) must be installed flush
against the mounting surface.
It is recommended that you cutout the surface slightly smaller than what is outlined in the installation drawings so that you
can make any necessary cutout adjustments.
1. Prepare the area by removing any screws or nails from the surface before beginning the cutout process.
2. Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 43 and for the 15-inch Wall Mount using
the dimensions shown in FIG. 44.
FIG. 43
NXD 12-inch Wall Mount panel dimensions using #4 mounting screws
FRONT BEZEL
SECURE UNIT WITH #4 SCREWS.
SURFACE (PODIUM, DESK, ETC.).
WHEN MOUNTING UNIT TO A SOLID
THESE 4 HOLES ARE ONLY REQUIRED
CUTOUT
To Next Page
Loading...
