Installation Procedures: 12" and 15" Panels
51
Modero VG Series Touch Panels - Instruction Manual
NOTE: The drywall clip set must be re-ordered from AMX if the drywall clip is bent accidentally during an installation or removed
during a re-installation.
11. Place the magnetic faceplate (A in FIG. 42) back onto the main NXD unit (B in FIG. 42). Make sure to align the Microphone,
Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.
12. Connect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the
NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
13. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
FIG. 42
Wall Mount panel (NXD) installation configuration for drywall surfaces
B - Main NXD unit consists of
Install the four drywall
clip sets (included)
into these holes
the touch panel and housing
4 notches are
required if the
unit is installed in
drywall using the
four (4) provided
drywall expansion
A - Faceplate
(bezel)
clips
Mounting Tab
To Next Page
Loading...
