Displaying Stream Content
136
Modero VG Series Touch Panels - Instruction Manual
14. Click the Apply button to save the encoding profiles to the MAX-CSE.
NOTE: If using RTP, both the Target Port and Target Audio Port must be different and should use even numbers.
Step 3: Conf iguring the MAX-CSE audio/video inputs
1. Complete the MAX-CSE connection and wiring procedures outlined within the Wiring the MAX-CSE connectors and cables
section of the MAX-CSE Instruction Manual.
2. Access the A/V Setup page (FIG. 134) by clicking the A/V Setup link from within the Navigation frame. This page provides the
user with the ability to select the source of the incoming video signal (from either the rear Composite or S-Video port), the
format of the incoming video (NTSC/PAL), and the gain given to the incoming audio signal.
3. From within the Video section of this page, check off the appropriate Video In and Video Port radio boxes which correspond to
both the type of video signal being used and its associated format.
For the purpose of these procedures, we’ve chosen to feed an NTSC signal into the rear Composite video connector. As a
result, a user should "check-off"/select both the Composite and NTSC radio boxes.
4. If you are feeding a microphone audio signal into the rear MAX-CSE microphone connector, you could use the Microphone Gain
field to enter an audio level (0 - 99) associated with the gain used by the rear microphone input.
NOTE: At any time, the user can choose to mute the incoming microphone signal by either toggling the state of the Microphone
icon located at the top of the page or entering a value of zero into the Mic Gain f ield.
FIG. 133
Stream Profiles page (showing a sample configuration)
FIG. 134 A/V Setup page
These port values must use
even numbers
Video Port and Video Format
Mic Gain value for incoming
audio signal
To Next Page
Loading...
