Touch Panel Accessories
35
Modero VG Series Touch Panels - Instruction Manual
7. Locate the terminal ends of the antennas and apply downward pressure to "snap" them onto their gold-tipped counterparts on
the mini-PCI card (FIG. 18). Carefully push down on each connector to verify it is securely joined to the card.
NOTE: It is recommended that any upgrade of internal equipment be done simultaneously in order to reduce the risk of damage to
internal components. If you are also installing an NXA-RGB card (as part of an NXA-RGBKIT), refer to the installation procedures on
page 23 before replacing the outer housing.
Step 3: Install the NXA-RGB Card Component (NXT)
1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the RGB card’s slot connector on the main board and align it with its counterpart on the bottom of the NXA-RGB card.
3. Carefully, but firmly, insert the NXA-RGB card into the RGB connector slot on the main board until both the card rests atop the
four raised securing holes and the RGB RJ-45 connector is evenly aligned with the other RJ-45 connectors on the back of the
panel.
4. Use a grounded Phillips-head screwdriver to secure the four NXA-RGB pan-head securing screws to the raised securing holes
on the main board.
5. To complete the upgrade process, either upgrade the remaining component (Step 3) or close and re-secure the enclosure
using the procedures in Step 5: Close and Re-secure the NXT Panel Enclosure section on page 37.
FIG. 18
Installation of the mini-PCI card connector on main board
FIG. 19 Location of the NXA-RGB card and I/O plate
Connection point
between the braces and
the mini-PCI card
Antennas connectors
RGB I/O
NXA-RGB card
Outer Housing
NXA-RGB card
screw locations (4)
connector plate
To Next Page
Loading...
