Touch Panel Accessories
28
Modero VG Series Touch Panels - Instruction Manual
Wiring and Connection Information
FIG. 9 shows a top view of the finished cable.
The following table provides the wiring information for each of the four (4) available connectors on each side of the NXA-MTC/RGB
Tabletop Cable.
Installing CAT5 Suppression Ferrites
Before connecting the RJ-45 cables to the Modero Touch Panel, install the necessary number of CAT5 Suppression Ferrites
(FIG. 10) to the RJ-45 Audio/Video cable. These Ferrites come as part of the Installation Kits mentioned in the previous
Specification table (page 27).
NOTE: No tools are required for this installation.
Associated Touch Panels (where used)
FG2251-61RGB NXD-1200VG RGB KIT, 12" MODERO WALLMOUNT RGB KIT
FG2250-61RGB NXT-1200VG RGBKIT, 12" MODERO TABLETOP RGB KIT
FG2253-61RGB NXD-1500VG RGB KIT, 15" MODERO WALLMOUNT RGB KIT
FG2252-61RGB NXT-1500VG RGB KIT, 15" MODERO TABLETOP RGB KIT
FG2256-61RGB NXD-1700VG RGB KIT, 17" MODERO WALLMOUNT RGB KIT
FG2257-61RGB NXT-1700VG RGB KIT, 17" MODERO TABLETOP RGB KIT
FG2255-11 NXA-RGBKIT, RGB UPGRADE KIT FOR EXISTING VG PANELS
FIG. 9 Finished NXA-MTC/RGB Tabletop Cable - showing standard terminations
Wire Table
Wire Connector 1 Connector 2 Connector 3 Connector 4
1 White/Orange White/Orange Red White/Orange
2 Orange/White Orange/White Black Orange/White
3 White/Green White/Green - White/Green
4 Blue/White Blue/White - Blue/White
5 White/Blue White/Blue - White/Blue
6 Green/White Green/White - Green/White
7 White/Brown White/Brown - White/Brown
8 Brown/White Brown/White - Brown/White
FIG. 10 Installing the CAT5 Suppression Ferrites
Red
Red
1
3
2
6 inches 3 inches
To Touch Pan el
To Breakout Box
4
1
3
2
4
Connector 3 - used for Power
Connector 4 - used for RGB (Blue)
Connector 1 - used for Audio/Video (Black)
Connector 2 - used for Ethernet (White)
Release the latch to
open the plastic
enclosure.
Insert the CAT5
cable and close
the enclosure.
Push down on the
enclosure until it
snaps closed.
To Next Page
Loading...
