Touch Panel Accessories
41
Modero VG Series Touch Panels - Instruction Manual
6. Firmly grip both the panel (from the side) and battery base (from below) together.
7. Gently place the touch panel LCD facedown onto a soft cloth (this prevents scratching of the LCD while the battery base is
being secured).
8. Locate the captive fasteners on the underside of the battery base by angling the base combo slightly forwards.
9. Secure each captive fastener head using a grounded flat-head screwdriver until the NXA-BASE/B is securely attached to the
underside of the NXT Modero touch panel.
10. Firmly grip the panel LCD/base combo and gently rotate the unit back onto the base.
Installing an NXT-BP Into the NXA-BASE/B
The battery base does not directly connect to a power supply, but rather receives its power directly from the Modero panel, through
the Panel Interface connector.
NOTE: Remove any connectors from the rear of the Modero NXT panel before continuing with the installation of the batteries. Power
can only be supplied after the batteries have been installed.
1. With the panel mounted on the battery base, open the battery compartment (FIG. 30) by pulling the handle outwards. This
compartment houses two NXT-BP batteries.
FIG. 29
NXA-BASE/B shown aligning with NXT panel
FIG. 30 Battery installation procedure
Panel Interface
connector
Alignment
pegs
Interface
connector
Captive
fasteners
(male)
To p vi ew
Bottom view
(female)
Battery
Compartment
NXT-BP Battery #2
Battery
Connectors
Battery
Connector
Port
Interface
connector
FRONT
NXT-BP Battery #1
Battery #2
slot
To Next Page
Loading...
