Modero VG Series Touch Panels
13
Modero VG Series Touch Panels - Instruction Manual
The RGB Kits include the following components:
Modero VG-Series Touch Panel (NXD or NXT) (FG225X-XXRGB)
NXA-AVB/RGB Breakout Box (FG2254-11)
NXA-RGB internal RGB/VGA Interface Card (FG2260) (pre-installed)
NXA-MTC/RGB Modero 10’ foot Table Top Cable (with RGB connector) (CA2250-70)
NXA-RGBCBL, 15-pin to 5X BNC RGB Breakout cable (FG2250-80)
Product Specifications - NXD/T-1200VG
The following table outlines the specifications for VG-Series of 12" Modero panels.
NXD/T-1200VG Specif ications
Dimensions (HWD): • NXD-1200VG (with faceplate): 12.38" x 12.59" x 3.25"
(31.43 cm x 31.97 cm x 8.25 cm)
• NXT-1200VG (Fully raised): 10.91" x 12.34" x 12.50"
(27.70 cm x 31.33 cm x 31.75 cm)
• NXT-1200VG (Fully lowered): 6.77" x 12.34" x 12.50"
(17.20 cm x 31.33 cm x 31.75 cm)
• CB-TP12 (conduit/wallbox): 11.52" x 11.60" x 3.50"
(29.27 cm x 29.47 cm x 8.89 cm)
• MB-TP12 (VESA mounting box): 12.37" x 12.58" x 3.52"
(31.42 cm x 31.95 cm x 8.94 cm)
Power: • Constant current draw: 2.3 A @ 12 VDC (stand-alone)
• Startup current draw: 3.5 A @ 12 VDC (stand-alone)
Minimum power
supply required:
PSN4.4 Power Supply (FG423-45)
- using accessories can increase the power draw requirements
Memory: 256 MB on-board memory
Compactflash: 2GB or greater (upgradeable to 4GB - see Other AMX Equipment).
Note: AMX may increase Compactflash size at any time in response to market availability.
Weight: 10.80 lbs (4.90 kg)
LCD Parameters: • Aspect Ratio: 4:3
• Brightness (luminance): 250 cd/m2
• Channel transparency: 8-bit Alpha channel transparency
• Contrast ratio: 300:1
• Display area (HW): 183.10 mm x 247.40 mm
• Display colors: 256K (18-bit color depth)
• Dot/Pixel pitch: 0.297 mm
• Screen resolution (HV): 800 x 600 pixels
• Video formats: NTSC, PAL, and SECAM (shown within variable-size video windows)
Active Screen Area: 9.69” x 7.26” (24.60cm x 18.45cm)
Viewing Angles: Vertical: + 80° (up from center) and - 80° (down from center)
Supported Audio
Sample Rates:
48000Hz, 44100Hz, 32000Hz, 24000Hz, 22050Hz, 16000Hz, 12000Hz, 11025Hz, and 8000Hz.
Certifications: FCC Part 15 Class B, CE, and EN 60950
Supported Transport
Protocols:
• RTP (MPEG-2/MPEG-4 Transport Stream)
• UDP (MPEG-2 Transport Stream)
Supported Audio
Codecs:
• Advanced Audio Coding (AAC)
• MPEG Audio Level 2 (MP2) / MPEG Audio Level 3 (MP3)
Supported Video
Codecs:
•MPEG-2
•MPEG-4
Front Panel
Components:
• Light Sensor: Photosensitive light detector for automatic adjustment of the panel brightness
• Motion Sensor (PIR): Proximity Infrared Detector to wake the panel when panel is approached
• Front Setup Access Button: Pushbutton (grey) used to either put the panel into a "sleep" or "wake" state
• Microphone: Used for intercom applications
• Speakers: Stereo output with a frequency response of 450 Hz - 7 KHz
Rear Panel
Components:
• RGB Connector: Made available only by using an NXA-RGB interface card installed within the touch panel.
Used with Component/RGB signals
• Audio/Video Connector: RJ-45 connector for communication of differential audio/video signals
• Ethernet 10/100 Port: RJ-45 port for 10/100 Mbps communication
• PWR Connector: 2-pin 3.5 mm mini-Phoenix connector
• Stereo Output Connector: Stereo output through a 3.5mm mini-jack
• USB Connector: Two Type-A USB ports
• Mini-USB Connector: 5-pin Mini-USB connector
To Next Page
Loading...
