Installation Procedures: 12" and 15" Panels
55
Modero VG Series Touch Panels - Instruction Manual
7. Secure the panel to the NXA-RK frame by first inserting and then tightening the four #4-40 screws (provided). Line up the
four mounting holes and use a grounded Phillips-head screwdriver to tighten the screws in a clockwise direction.
8. Insert the NXA-RK (with connected NXD unit) into the equipment rack, making sure to align the screw holes along the sides on
the NXA-RK with the holes in the equipment rack.
9. Use a grounded Phillips-head screwdriver to secure the NXA-RK (with connected NXD unit) to the equipment rack using #10-
32 screws (not included).
10. Place the magnet faceplate back onto the main NXD unit by gripping the faceplate and placing it on the housing with gentle
force. Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/
faceplate.
11. Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the
NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
12. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
FIG. 46
NXD 12 inch Wall Mount panel installed into an NXA-RK12 Rack Mount Kit
FIG. 47 NXD 15 inch Wall Mount panel installed into an NXA-RK15 Rack Mount Kit
Faceplate
Rack mount frame
(NXA-RK12)
Faceplate
Rack mount frame
(NXA-RK125)
To Next Page
Loading...
