Configuring Communication
91
Modero VG Series Touch Panels - Instruction Manual
7. Click Yes from the Security Alert popup window to agree to the installation of the G4 WebControl application on your
computer. This application contains the necessary Active X and VNC client applications necessary to properly view and control
the panel pages from your computer.
NOTE: The G4 Web Control application is sent by the panel to the computer that is used for communication. Once the
application is installed, this popup will no longer appear. This popup will only appear if you are connecting to the target panel
using a different computer.
8. In some cases, you might get a Connection Details dialog (FIG. 89) requesting a VNC Server IP Address. This is the IP Address
not the IP of the Master but of the target touch panel. Depending on which method of communication you are using, it can be
found in either the:
Wired Ethernet - System Settings > IP Settings section within the IP Address field.
Wireless - Wireless Settings > IP Settings section within the IP Address field.
If you do not get this field continue to step 9.
9. If a WebControl password was set up on the G4 WebControl page, a G4 Authentication Session password dialog box appears
on the screen within the secondary browser window.
10. Enter the Web Control session password into the Session Password field (FIG. 88). This password was previously entered into
the Web Control Password field within the G4 Web Control page on the panel.
11. Click OK to send the password to the panel and begin the session. A confirmation message appears stating "Please wait, Initial
screen loading.".
The secondary window then becomes populated with the same G4 page being displayed on the target G4 panel. A small circle
appears within the on-screen G4 panel page and corresponds to the location of the mouse cursor. A left-mouse click on the
computer-displayed panel page equates to an actual touch on the target G4 panel page.
FIG. 89
Connection Details dialog
IP Address of touch panel
- obtained from IP Settings section of
the System Settings page
To Next Page
Loading...
