Upgrading Modero Firmware
94
Modero VG Series Touch Panels - Instruction Manual
NOTE: The panel firmware is shown on the right of the listed panel. Download the latest firmware file from www.amx.com and
then save the KIT file to your computer.
5. If the panel firmware being used is not current, download the latest Kit file by first logging in to www.amx.com and then
navigate to Te ch Ce nt er > Firmware Files and from within the Modero section of the web page locate your Modero panel.
6. Click on the desired Kit f ile link and after you’ve accepted the Licensing Agreement, verify you have downloaded the Modero Kit
f ile to a known location.
7. From within Studio, select Too ls > Firmware Transfers > Send to NetLinx Device from the Main menu to open the Send to
NetLinx Device dialog (B in FIG. 92). Verify the panel’s System and Device number values match those values listed within the
System folder in the OnLine Tree tab of the Workspace window (A in FIG. 92).
8. Select the panel’s KIT file from the Files section.
9. Enter the Device value associated with the panel and the System number associated with the Master (listed in the OnLine Tree
tab of the Workspace window). The Port field is disabled.
10. Click the Reboot Device checkbox. This causes the touch panel to reboot after the firmware update process is complete. The
reboot of the panel can take up 30 seconds after the f irmware process has f inished.
11. Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog (B in FIG. 92).
12. As the panel is rebooting, temporarily unplug the USB connector on the panel until the panel has completely restarted.
13. Reconnect the USB connector to the panel.
14. Right-click the associated System number and select Refresh System. This causes a refresh of all project systems, establishes
a new connection to the Master, and populates the System list with devices on your particular system.
15. Confirm the panel has been properly updated to the correct firmware version.
FIG. 92
Using USB for a Virtual Master transfer
To Next Page
Loading...
