Section 4 Unit Operation
4-16
Input terminal : Input2 (1 MΩ)
Measurement
Resolution
1 mHz
10 mHz
100 mHz
1 Hz
10 Hz
100 Hz
1 kHz
10 kHz
100 kHz
1 MHz
[ ] Key Function
[ ] Key Function
10 000 000. 000
MHz kHz Hz
10 000 000. 00
MHz kHz Hz
10 000 000. 0
MHz kHz Hz
10 000 000.
MHz kHz Hz
10 000 00
0
MHz kHz Hz
10 000 0
00
MHz kHz Hz
10 000
MHz kHz
10 00
0
MHz kHz
10 0
00
MHz kHz
10
MHz
Display
Fig. 4-13 Frequency Display (Measured at an Input Impedance of 1 MΩ)
When measuring the carrier frequency of burst signal, the pulse width of the burst signal determines the maximum fre-
quency resolution that can be measured. When you set a frequency resolution that is higher than the maximum frequency
resolution that can be measured, the unit will display UNCAL and then measure at the maximum frequency resolution
possible.
The unit will display the following when the frequency resolution is set to 1 kHz and the measurement result could only
obtain a resolution up to 10 kHz.
20 000 00
*
GHz MHz kHz
To Next Page
Loading...