Section 4 Unit Operation
4-32
4.3.13 Hold
This function stops frequency measurement operation and maintains the display of the final measurement value. Pressing
the [Hold] key lights the LED above the key to let you know that the unit is in the hold state.
Pressing [Restart] or setting parameter by the panel key, at this time makes one measurement and then once again enters the
hold state. In addition, when statistics processing is active, it calculates the first statistics processing result and then once
again enters the hold state. Pressing the [Hold] key while in the hold state turns out the LED and enters the normal
measurement state in which you can perform continuous measurements.
4.3.14 Restart
Pressing [Restart], this function restarts frequency measurement. During statistics processing, it clears the sample mea-
surement execution count and then starts statistics processing from the first sample. When in the hold state, this function
performs one measurement or runs one statistics process and then enters the hold state once again.
To Next Page
Loading...