Section 4 Unit Operation
4-44
4.4.6 Burst Wave Measurement via Input1
(Frequency Acquisition Mode = Manual; Level Acquisition Mode = Manual)
Setting Measurement Mode to Burst allows you to measure the carrier frequency, pulse width, and pulse repetition period
of the pulse-modulated signal. Perform steps (1) and (2) below.
(1) Connecting the input signal
Connect the signal to measure to the Input1 connector on the front panel.
Note:
Do not connect a signal of +10 dBm or higher to the Input1 connector.
(2) Setup
1) Press the [Preset] key to preset this unit.
2) Select the Burst mode.
Press the [Meas Mode] key. The Burst LED lights up.
3) For how to set the manual frequency value, see Section 4.4.2.
4) For how to set the manual amplitude discrimination value, see Section 4.4.3.
5) To measure the pulse width and pulse repetition period at the same time, follow the procedure discussed in
Section 4.4.7.
To Next Page
Loading...