DRIVER INSTALLATION
85
the diskette from the drive and click Yes to restart the computer
to load the new drivers.
12. See Chapter 5 in this manual for information on customizing
your RAID volumes using McRAID Storage Manager.
4.2.3.1 Making Volume Sets Available to Windows
System
When you reboot the system, log in as a system administrator.
The following steps show how to make any new disk arrays or
independent disks accessible to Windows 2000/XP/2003/Vista.
This procedure assumes that the SAS RAID controller hardware,
driver, and Windows are installed and operational in your sys-
tem.
1. Partition and format the new arrays or disks using “Disk Ad-
ministrator”:
a. Choose “Administrative Tools” from the “Start” menu.
b. Choose “Computer Management” from the “Administrative
Tools” menu.
c. Select “Storage”.
d. Select “Disk Management”.
2. Follow the on-screen prompts to write a signature to the
drive.
3. Right click on the drive and select “Create Volume” from the
menu.
4. Follow the on-screen prompts to create a volume set and to
assign a disk drive letter.
4.2.4 Uninstall controller from Windows 2000/
XP/2003/Vista
To remove the SAS RAID controller driver from the Windows sys-
tem, follow the instructions below.
To Next Page
Loading...
