Areca ARC-1222 - Page 93

93
ARCHTTP PROXY SERVER INSTALLATION
usr/local/sbin). Or
(1). Download from the www.areca.com.tw or from the email
attachment.
2. You must have administrative level permissions to install SATA
RAID controller ArcHttp software. This procedure assumes that the
SATA RAID hardware and driver are installed and operational in
your system.
The following details are the installation procedure of the SATA
RAID controller for Mac ArcHttp software.
(1).Run the Archttp proxy server by using the following command:
Usage: ./archttp32 (TCP_PORT) or ./archttp64 (TCP_PORT). It
depends on your OS version.
Parameters: TCP_PORT value= 1~65535 (If TCP_PORT assigned,
Archttp will start from this port. Otherwise, it will use the setting in
the archttpsrv.conf or default 81). This is the port address assigning
for the archttp conguration (Cfg Assistant).
Such as: archttp64 1553
(2). Archttp server console started, Controller card detected then
ArcHttp proxy server screen appears.
Copyright (c) 2004 Areca, Inc. All Rights Reserved.
Areca HTTP proxy server V2.00 for Areca RAID controllers.
Controller(s) list
--------------------------------------------
Cfg Assistant: Listen to port[1553].
Controller[1](PCI): Listen to port[1554].
Binding IP:[0.0.0.0]
Note: IP[0.0.0.0] stands for any ip bound to this host.
--------------------------------------------
##############################
Press CTRL-C to exit program!!
##############################
Controller [1] Http: New client [9] accepted
Controller [1] Http: New Recv 243 bytes
Controller [1] Http: Send [174] bytes back to the client