PU-4010 1-10
First, set up the instrument. Start with any of the following sections according to your needs.
• For battery operation, see this page.
• For use with the printer, go to page 1-12.
• For AC-power operation without the printer, go to page 1-13.
1-4-1 For Battery Operation
Place two AA alkaline batteries in the instrument. Battery operation is useful when carrying
the instrument with you. Batteries have a use life of about 500 sample tests.
While lightly pressing the battery cover on
the bottom, slide the cover in the direction
of the triangle mark (
) to remove.
Place two AA alkaline batteries in the
correct direction in the battery
compartment (see the figure).
Slide the battery cover back in position
until it snaps into place.
This completes the setup. Go to “2-1. Operation Flow Chart” on page 2-1.
1-4 Instrument Setup
NOTE: Use alkaline batteries only, not manganese batteries. The printer cannot run on
batteries.
Battery cover
1
2
NOTE: Remove the old batteries before
placing new ones.
3
NOTE: Dispose of old batteries according to your local environmental
regulations.
To Next Page
Loading...
Need help?
General
