PU-4010 2-6
2-4-2 Setting Measurement Number
Set the measurement number (up to 4 digits) for the sample to be tested. The numbers of the
second and subsequent samples will automatically increment by one. The measurement
number is retained even if the power is turned off, unless you set a new measurement number.
On the standby screen, press the
button once.
• The current measurement number will appear
and the
icon will blink.
Press the button.
• The cursor ( _ ) and icon will blink.
Enter the measurement number using the
numeric buttons.
• A measurement number can contain up to 4
digits.
REFERENCE: To delete the number one digit at a time, press and release the button. To
clear the entire entry, press and hold the button for one second.
Press the button.
• This will confirm your entry and the standby
screen will appear again.
REFERENCE: On the standby screen, the
measurement number will suppress any
zeros. For example, if your entry is “0123”,
you will see “123” on the display.
Go to “2-4-3. Setting Patient ID” on the next page.
1
2
3
4
To Next Page
Loading...
Need help?
General
