Arkray PU-4010 - Installation Precautions

PU-4010 iv
Before installation of the instrument, read the instructions in this section and always take
proper safety precautions.
4 Installation Precautions
7 cm
(3 inches)
7 cm
(3 inches)
For the test strip holder to move freely,
leave at least 7 cm (3 inches) of space to
the right and left sides of the instrument.
Remove old batteries. Also, remove
batteries before long periods of non-use.
1 hour
or more
Temperature: 10-30°C
Humidity: 20-80%
If the instrument is subjected to sudden
temperature changes, allow instrument to
adjust to room temperature for 1 hour
before testing.
Use the instrument where temperature and
humidity can be maintained between 10°C
and 30°C and between 20% and 80% RH.
To run the instrument on AC power,
connect the instrument to an AC receptacle
using the AC adapter that came with the
instrument.
If you detect abnormal noise, odors or
smoke, immediately turn off the power,
unplug the AC adapter and contact your
distributor.