ARRI ALEXA - Page 170

170 Appendix Infos and Warnings
Card 1: Rec protected The SxS PRO card in slot 1 is Rec protected.
Remove the card from the camera, slide the
switch located on the camera back end to the
Rec enable position and re-insert the card.
Card 2: Rec protected The SxS PRO card in slot 2 is Rec protected.
Remove the card from the camera, slide the
switch located on the camera back end to the
Rec enable position and re-insert the card.
Card 1: Full SxS PRO card in slot 1 is selected, but the
SxS PRO card is full. Use a new card. Card in
other slot can still record.
Card 2: Full SxS PRO card in slot 2 is selected, but the
SxS PRO card is full. Use a new card. Card in
other slot can still record.
Card 1: Wrong file
system
The SxS PRO card in slot 1 is not formatted in
the file system required by the camera. Format
the card.
Card 2: Wrong file
system
The SxS PRO card in slot 2 is not formatted in
the file system required by the camera. Format
the card.
Card 1: Card is too
slow
The write speed of SxS PRO card in slot 1 is
insufficient for the sensor fps set on the
camera. Use a card with a higher write speed.
Card 2: Card is too
slow
The write speed of SxS PRO card in slot 2 is
insufficient for the sensor fps set on the
camera. Use a card with a higher write speed.
Camera overheating The camera system's temperature is reaching
a critical level. this can either be due to a
blocked camera fan or ambient temperature
exceeding the system's limits. Apply additional
cooling or switch of the camera to prevent
hardware damage.
Low sensor
temperature
The sensor temperature is lower than it should
be. High image quality is still guaranteed.
High sensor
temperature
The sensor temperature is higher than it should
be. High image quality is still guaranteed.
External TC: Different
frame rate
The external TC signal's time base differs from
the project fps of the camera. Syncing is still
possible.
Re-jam Timecode
soon
Accuracy of jammed Timecode can soon
expire. Re-jam camera with external Timecode
soon.
Re-jam Timecode now Accuracy of jammed Timecode has expired.
Re-jam camera with external Timecode.
TC source forced to
internal
Sensor fps does not match Project fps.
External Free Run TC cannot be used, camera
has switched to Int Rec Run TC.
Interface bit error Reboot camera. If error continues to occur,
contact ARRI service.