40 Connectors
9.1 BAT
The BAT connector can be used to power the camera from an external
power source with cables KC-20S and KC-29S.
It is located on the camera back lower right.
9.2 REC OUT 1 + 2
The REC OUT consists of two BNC plugs capable of carrying 1920x1080
1.5G or 3G HD-SDI signals with frame rates from 23.976 to 60 fps according
to SMPTE standards 274M, 292M, 372M and 425M. In addition, it outputs
ARRIRAW in a proprietary format that is supported by a range of 3rd party
recorders. RGB 444 at frame rates of 48, 50, 59.94 and 60 fps is output in a
proprietary format utilizing two 3G connections. The signal format can be
changed in the camera menu.
The connectors are located on the camera back mid right.
9.3 RET/SYNC IN
Via the RET connector a return signal from another image source can be fed
into the camera for displaying on EVF and/or MON OUT. The signal must be
a 1920x1080 422 1.5G single link according to SMPTE 274M and 292M.
The output routing of the RET in signal can be set in the camera menu.
It is located on the camera back mid right.
9.4 MON OUT
The MON OUT is a single BNC connector capable of carrying a 1920x1080
422 YCbCr 1.5G HD-SDI signal with frame rates of 23.976, 24, 25, 29.97 or
30 fps according to SMPTE standards 274M and 292M. The signal format
can be changed in the camera menu.
It is located on the camera back upper right.
9.5 EXT
The EXT connector is a multi-pin accessory connector. It carries signals for
communication with various accessories and 24V power. The maximum
power output is 2.2A, shared with the RS outputs.
Cables are currently available for:
Connecting a UMC-3 remote motor controller
To Next Page
Loading...
