26 Power Supply
damage to the battery and unpredictable camera behavior. Any camera-battery
combination should be tested prior to use, especially when accessories are powered
through the camera.
7.8 Power Outputs
The camera has three power outputs for accessories, 2x 24 V and 1x 12 V.
Figure 10: 24 V outputs (RS) and 12 V output
7.8.1 12 V Accessories
The 12 V output is located on the right side of the camera and has a 2-pin
LEMO connector. It is limited to 12 V and can supply a device with a current
of up to 2.2 A, depending on the camera power supply.
7.8.2 24 V Accessories
Two RS outputs are located on the right side of the camera. They have a 3-
pin Fischer connector. They can supply two devices with a combined load of
up to 2.2 A (shared with the EXT connector power out), depending on the
camera power supply. When the camera is powered from a source with a
voltage below 24 V, they output 24 V. If the camera's power source is
supplying more than 24 V, this voltage level is also present on the RS
outputs.
Besides powering accessories, these sockets can also be used to send a
remote start+stop signal to the camera.
To Next Page
Loading...
