30 Installation of The Camera
Figure 12: EVF cables: KC-150S (center), KC-151S (middle), KC-152S
(outer)
8.3.2 Viewfinder Mounting Bracket
The viewfinder mounting bracket VMB-1 / VMB-2 is attached to the camera
with two 3mm Allen screws at the very front of the camera top. The
viewfinder is attached to the mounting bracket by sliding the dove tail into the
receptacle of the mounting bracket and then closing the lever on the
viewfinder.
The position of the viewfinder can be adjusted by loosening the levers of the
mounting bracket, adjusting the position as desired and closing the levers.
It can be flipped over by first unscrewing the cap at the end of the side
adjusting rod, then removing the rod itself and inserting it into its mount from
the other side. Then reattach the cap.
Note: Camera right operation is not possible with the standard EVF cable KC-150-S.
Instead, the longer cable KC-151-S is needed.
Figure 13: VMB-1 on camera
To Next Page
Loading...
