Infos and Warnings Appendix 173
Low sensor
temperature
Sensor temperature is out of range. Wait until
error message disappears before continuing to
shoot.
High sensor
temperature
Sensor temperature is out of range. Wait until
error message disappears before continuing to
shoot.
System error Reboot the camera.
Codec error - Reboot! An error in the compression module has
occured, and recording was aborted. Reboot
the camera before you continue to record!
Sensor error. Reboot! The image sensor has a problem. reboot the
camera.
Sensor boot error! The sensor has not booted. Reboot the
camera.
Fan error. Contact
service!
The fan module is not working properly. Either
install an SFM-1, or contact the ARRI service.
Fatal system error!
Reboot camera now!
Camera has to be rebooted. If this error
continues to occur, a hardware problem might
be the reason. Contact the ARRI service.
Sync clock out of
range
The sync signal clock does not match the
camera setting. Make sure the settings match!
Syncing sensor.
Please wait!
Slave camera syncs to master camera. Wait
until message disappears before starting to
shoot!
A slave is not ready One of the slave cameras is not ready for
recording.
Software error - reboot
camera!
A part of the camera software has stopped
functioning properly and requires a camera
reboot.
SxS: Audio recording
failed
Audio recording on SxS card failed
REC OUT: Frame
drops. Set frame rate!
Frame rate of REC OUT is smaller than sensor
fps. Make sure REC OUT frame rate matches
sensor fps.
SxS cards differ.
Recording prohibited!
With dual recording active, the two SxS cards
must have identical file structure. Use two fresh
SxS cards and analyze the not matching ones.
If any error that requires rebooting continues to occur regularly, contact the
ARRI service.
To Next Page
Loading...
