4.12 Cup heater
The cup heater is for heating cups before they are
used.
Place the cups to be heated on the appropriate
surface (1).
To activate the cup heater, press the button (
)
on display.
To turn it o, press the button
(
) again.
The cup heater light is red when
it is warming up.
to change the temperature of
the cup heater, proceed as listed in
chapter "27-Programming".
1
!
If the cup heater is set to a temperature lower than
70 °C in the adjustment menu, it will remain o,
even if switched ON.
!
For safety reasons, it is advisable not to place cloths
or other objects on the cup heater (1).
Cup heater
ON/OFF
4.13 Cappuccino maker
The cappuccino maker allows to:
• foam the milk, obtaining a soft and silky cream
• simply heat up the milk;
• carry out the automatic sterilization.
Apply the cappuccino maker, using the appropriate
tting, directly to the steam spout, by replacing the
original sprayer, or through the appropriate hose, directly
to the steam knob of the machine.
Ensure that seal (2) is present and/or use Teon tape
in order to avoid steam loss which may compromise the
cappuccino maker's operation.
Insert the milk drawing hose (10) into the appropriate
connection (1) of the cappuccino maker.
To change the temperature of the milk apply the
adaptors as shown in the table below.
2
310
9 8
4
5
67
1
table of temperatures with and without reductions
(temperatures measured in a pre-heated cup)
Milk temperature Without use of
adaptor
With WHITE
adaptor
Ø 1,9mm
With RED
adaptor
Ø 1,8mm
Room temperature
16°C
55 - 60 °C 60 - 68 °C 68 - 75 °C
Chilled milk 6°C 48 - 56 °C 58 - 63 °C 63 - 70 °C
To Next Page
Loading...
