13.7 Update text
With this command you can update
the text used in the menu, in the various
languages used.
To update, press this command, then
the machine will load the new menu texts.
Update text
13.2 Update resources
This item is used to update the graphic
resources that make up the menu of the
display.
To update, press "Update Resources",
then wait while the new graphics is
being loaded.
Update resources
13.4 Save data
With the supplied USB stick, you can
save all the machine settings (temperatures,
pressures, energy saving, etc.).
press the "Save data" key and wait for
the data to be completely saved;
Save data
13.5 Load data
It is possible to load the previously
saved data from the USB stick, and reset
all the parameters automatically.
• press the "Load data" key and wait for
the data to be completely loaded;
• in the end, the machine is automatically set with the
loaded data.
Load data
13.6 Default
Through this menu, you can restore the
factory (default) settings of the machine.
Press "Default" to restore the data.
Default
13.3 Update TFT display
This item allows to update (via USB
stick) the software that manages the
touch screen display, located in the
display tab.
To update, press this command, then
the machine will load the new version of the display
management software, located on the USB stick; once
nished, check the new version of the software installed.
Update TFT Disp.
!
Do not remove the USB drive during data transfer.
i
If there is no data in the USB stick, "Load data" will
not appear in the Menu.
!
Do not remove the USB drive during update. If the
operation fails, it will be necessary to manually
turn the machine o and back on, inserting the
USB drive supplied by the manufacturer.
13.8 Update logo
With this command, you can customize
your logo and the screen saver on the
display.
Once you press the button, the
software will load the new logo prepared
beforehand, which located is on the USB stick.
Below are the instructions for the preparation of the
logo and the screen saver.
Preparation of the logo
For the installation of the new logo on the display
of the machine, you must replace the le "custom.bin"
located on the USB stick supplied, in the CUSTOM folder,
with the new one containing the custom graphics.
To generate this le, a special tool is supplied, which
can be installed on any PC compatible with Windows
XP, 7 or 8.
Let's see how to proceed:
• If not already done so, install the build tool " Custom-
Builder-Setup-v1-0-0-0.exe" on a PC;
Update logo
To Next Page
Loading...
