Astoria Plus4YouTS - Scheduled Assistance; Grinders Wear Alert

60
Technical manual
17.2 Scheduled assistance
This function is related to the request for machine
assistance and provides notication of when to proceed
with ordinary scheduled maintenance.
The request for assistance appears when the number
of coee, tea, boiler lling cycles, or the number of days
passed since installation of the machine, have reached a
value equal to the cycle programmed by the technician.
All alerts appear on the top of the touchscreen display.
The alarms for reached/exceeded thresholds do not
prevent the machine from functioning.
The alarms can be reset at any time (also before the
alarm is engaged) by a technician following the procedure
described in chapter "Scheduled maintenance".
Functioning:
When the machine is functioning normally, the
system increases both the machine cycle counter and
the time since installation counter.
When the number of executed cycles is less than 1000
cycles in respect to the programmed threshold "A", the
alarm message in the following example appears.
If no maintenance operation is executed, the message
indicated above remains until the subsequent threshold
"B" alarm is reached:
Once threshold "B" has been reached, the alarm
message changes to the following:
If no maintenance operation is executed, the message
indicated above remains until the subsequent threshold
"C" alarm is reached:
The system also displays the installation date of the
machine (or the date of the last intervention) with the
date for required maintenance.
Two weeks prior to reaching the programmed
threshold, the following message appears on the display:
The A - B - C meters are independent from one another
and are therefore reset independently.
To reset the alarms, refer to the "Scheduled
maintenance" chapter.
!
To program the alarms, refer to the "Scheduled
maintenance" chapter.
17.3 Grinders wear alert
If enabled, this function displays a message to alert
the user when it is necessary to replace the grinders of
the coee grinder.
When the quantity in kilograms of coee used reaches
the threshold limit, the following warning is displayed:
The alarm for reached/exceeded thresholds do not
prevent the machine from functioning.
The count can be reset at any time (also before the
alarm is engaged) by a technician following the procedure
described in chapter "Scheduled maintenance".
For the programming, refer to the same chapter.
!
The system only works if the machine is paired with
only one grinder.
Maintenance
Service A
Maintenance
Service A
Maintenance
Service B
Maintenance
Service C
Maintenance
Service Plan
Maintenance
Wear ABD Blades