48
GigaX3112 Series Layer 3 Managed Switch
Figure 53. SNMPv3 VGU Table 1
4.7.4.2 VACM Group
VACM Group is used to configure the information of SNMPV3 VACM Group.
Group Name:
enter the security group name.
Read View Name:
enter the Read View Name that the Group belongs. The
related SNMP messages are Get,GetNext,GetBulk.
Write View Name:
enter the Write View Name that the Group belongs. The
related SNMP message is Set.
Notify View Name:
enter the Notify View Name that the Group belongs. The
related SNMP messages are Trap,Report..
Security Model:
enter the Security Model Name that the Group belongs.
Any is suitable for v1,v2,v3. USM is SNMPv3 related.
Security level:
enter the Security level Name that the Group belongs. Only
NoAuth, AuthNopriv, AuthPriv can be chosen..
Click on the
Add
when you create a new VACM group entry by the above
information. Then you will see the new added entry shows in the group window.
You can remove the existed group by selecting the entry with the mouse, then
clicking on
Remove
. The
Modify
button updates the existed VACM Group
entries. Click
OK
to save effective. Click
Reload
to refresh the settings to current
value. To make the configuration effective, please go to “Save Configuration”
page, then click on
Save
.
To Next Page
Loading...
Need help?
General