76
GigaX3112 Series Layer 3 Managed Switch
5.3.12 LACP
5.3.12.1 clear lacp counters
Use the clear lacp counters configuration command on the switch to clear the
statistics for all aggregated port sets.
CLI Syntax:
clear lacp counters [STACKID]
Example:
clear lacp counters 1
5.3.12.2 lacp aggregation-link trunk
This command sets the Link Aggregation Control Protocol (LACP) operation
add/set for the trunk group ports on the switch.
CLI Syntax:
lacp aggregation-link trunk STACKID (add|set) group <1-32>
PORTLIST
Example:
ASUS# lacp aggregation-link trunk 1 set group 1 1,2
5.3.12.3 disable lacp aggregation-link trunk
This command sets the Link Aggregation Control Protocol (LACP) operation
add/set or disable for the trunk group ports on the switch.
CLI Syntax:
lacp aggregation-link trunk STACKID disable <1-12>
Example:
ASUS# lacp aggregation-link trunk 1 disable 2
5.3.12.4 lacp port-priority
This command sets the port priority for the Link Aggregation Control Protocol
(LACP) on the switch.
CLI Syntax:
lacp port-priority <1-65535>
Example:
(config)# interface fa1/0/2
(config-if)# lacp port-priority 1000
5.3.12.5 lacp system-priority
This command sets the system priority for the Link Aggregation Control Protocol
(LACP) on the switch.
CLI Syntax:
lacp system-priority <1-65535>
Example:
(config)# lacp system-priority 20000
To Next Page
Loading...
Need help?
General