78
GigaX3112 Series Layer 3 Managed Switch
5.3.14.2 no mac-address-table multicast
Use the no mac-address-table multicast configuration command on the switch
to remove multicast static port to the MAC address table.
CLI Syntax:
no mac-address-table multicast MACADDR vlan VLANID
interface IFLIST
Example:
(config)# no mac-address-table multicast 0100.5e11.1111 vlan 2
interface gi1/0/3 1
5.3.14.3 show mac-address-table multicast
Use the show mac-address-table multicast user EXEC command to display the
Layer 2 multicast entries for all VLANs. Use the command in privileged EXEC
mode to display specific multicast entries.
CLI Syntax:
show mac-address-table multicast
Example:
ASUS# show mac-address-table multicast
5.3.15 IGMP Snooping
5.3.15.1 default ip igmp snooping
This command sets ip igmp snooping feature to default.
CLI Syntax:
default ip igmp snooping
Example:
(config)# default ip igmp snooping
5.3.15.2 ip igmp snooping
This command sets the IGMP snooping function enabled globally.
CLI Syntax:
ip igmp snooping
Example:
(config)# ip igmp snooping
5.3.15.3 interval time
This command sets the interval time for the IGMP queries sent by switch.
CLI Syntax:
ip igmp snooping last-member-query-interval TIMEVALUE
Example:
(config)# ip igmp snooping last-member-query-interval 100
To Next Page
Loading...
Need help?
General