72
GigaX3112 Series Layer 3 Managed Switch
5.3.5.3 interface vlan VLAN-ID
This command changes the operation to vlan interface command mode.
CLI Syntax:
interface vlan VLAN-ID
Example:
interface vlan 1
5.3.5.4 ip address
This command sets the ip address for specific interface.
CLI Syntax:
ip address A.B.C.D/M
Example:
(config-if)# ip address 192.168.20.121/24
Note: It wonʼt show you the interface name. Please keep in mind, which you are
configuring.
5.3.5.5 ip helper-address
This command is used to enable the function of DHCP relay for specific interface
CLI Syntax:
ip helper-address A.B.C.D
Example:
(config-if)# ip helper-address 192.168.1.180
5.3.5.6 ip ospf
This command is used to setup OSPF interface parameters
CLI Syntax:
ip ospf
Example:
(config-if)# ip ospf
5.3.5.7 ip pim
This command is used to setup PIM-DM interface parameters
CLI Syntax:
ip pim
E
xample:
(config-if)# ip pim dense-mode
5.3.5.8 ip rip
This command is used to setup RIP interface parameters
CLI Syntax:
ip rip
Example:
(config-if)# ip rip
To Next Page
Loading...
Need help?
General