82
GigaX3112 Series Layer 3 Managed Switch
5.3.20.2 default gvrp configuration
This command sets the GVRP configuration to default.
CLI Syntax:
default gvrp configuration
Example:
ASUS# default gvrp configuration
5.3.20.3 gvrp mode
This command sets the GVRP feature globally enable or disable on the switch.
CLI Syntax:
gvrp mode (enable|disable)
Example:
ASUS# gvrp mode enable
5.3.20.4 show gvrp configuration
To show gvrp configuration IFNAME status.
CLI Syntax:
show gvrp configuration IFNAME
Example:
ASUS# show gvrp configuration gi1/0/1
5.3.20.5 show gvrp statistics
To show gvrp statistics IFNAME status.
CLI Syntax:
show gvrp statistics [IFNAME]
Example:
ASUS# show gvrp statistics gi1/0/1
5.3.21 CoS/QoS
5.3.21.1 queue cos-map
Use the queue cos-map configuration command on the switch to set which Cos
queue a given priority should map into.
CLI Syntax:
queue cos-map PRIORITY QUEUE
Example:
ASUS# queue cos-map 1 3
5.3.21.2 show queue cos-map
This command sets the GVRP configuration to default.
CLI Syntax:
show queue cos-map
Example:
(config)# show queue cos-map
To Next Page
Loading...
Need help?
General