AudioCodes Mediant 1000B - 1 Introduction

Hardware Installation Manual 1. Introduction
Media Gateways & SBCs 11 Mediant 1000B Gateway & E-SBC
1 Introduction
This document provides a hardware description of the Mediant 1000B Gateway & E-SBC
(hereafter referred to as device) and step-by-step procedures for cabling the device.
The device is a 19-inch industrial platform chassis, 1U high and 13.8 inch deep. The
chassis' modular hardware design allows scalability to capacity demands and optional
telephony interfaces to suite your requirements.
The device supports the following interfaces:

Analog and Digital Telephony (Optional, customer-ordered):
• Up to four digital trunks modules, supporting up to 6 x E1 / 8 x T1 (1, 2, or 4
E1/T1/J1 PRI spans per module)
• Up to five BRI modules, where each module provides four BRI ports
• Up to six FXO modules, where each module provides four FXO ports
• Up to six FXS modules, where each module provides four FXS ports

(Optional, customer-ordered) Up to four Media Processing modules (MPM), providing
additional DSP resources for SBC transcoding and/or three-way conferencing

Up to seven LAN Ethernet interfaces:
• Three interfaces on the CRMX module
• (Optional, customer-ordered) Four interfaces provided by a LAN Expansion
module (SWX)

(Optional, customer-ordered) Open Solution Network (OSN) server modules for
hosting third-party applications (such as an IP PBX)

Dry-contact alarm relays for connection to an external audible or visual alarm system
(e.g., bell)

Fan Tray module

Up to two Power Supply modules
Notes:
• Hardware configurations may change without notice. Currently available hardware
configurations are listed in AudioCodes Price Book. For further enquiries, please
contact your AudioCodes sales representative.
• For information on configuring the device, refer to the device's User’s Manual.