AudioCodes Mediant 1000B - Figure 5-3: RJ-45 Connector Pinouts for LAN; Figure 5-4: Connecting to LAN

Mediant 1000B Gateway & E-SBC
Hardware Installation Manual 42 Document #: LTRT-41441
Cabling specifications:

Cable: Cat 5/5e

Connector: RJ-45

Connector Pinouts:
Figure 5-3: RJ-45 Connector Pinouts for LAN
 To connect to the LAN:
1. Connect one end of a straight-through RJ-45 Ethernet Cat 5/5e cable to the active
LAN port on the CRMX module or optional SWX module.
Figure 5-4: Connecting to LAN
2. Connect the other end of the cable to the LAN.
3. For 1+1 LAN protection, repeat steps 1 and 2 for the standby port, but connect it to
another network (in the same subnet).
Note: If you are implementing LAN port-pair redundancy, make sure that each port in the
Ethernet Group is connected to a different network (in the same subnet).