AudioCodes Mediant 1000B - Figure 6-10: Extracting Module from Slot; Figure 6-11: Inserting a Module into the Empty Slot

Hardware Installation Manual 6. Hardware Maintenance
Media Gateways & SBCs 67 Mediant 1000B Gateway & E-SBC
Figure 6-10: Extracting Module from Slot
5. Physically insert the new module into the same slot:
a. Gently insert the module into the empty slot, aligning the module with the rails in
the slot in the following module orientation, depending on whether you are
inserting it in the top- or bottom-row slots:
♦ Top-row slots: Ensure that the module is orientated such that the port-
number labels are located at the bottom of the module's front panel. This
module orientation is considered as facing up.
Figure 6-11: Inserting a Module into the Empty Slot
♦ Bottom-row slots: Ensure that the module is orientated such that the port-
number labels are located at the top of the module's front panel. This module
orientation is considered as facing down.
b. Push the module into the slot and press on it firmly to ensure that it has been fully
inserted.
c. Using a flathead screwdriver or your fingers, tighten the module's two captive
screws to secure the module to the chassis.
6. Reconnect the cables to the module. For non-hot swappable module replacement, skip
the next step and continue to Step 8; otherwise, for hot-swappable module
replacement, continue to Step 7.