Mediant 1000B Gateway & E-SBC
Hardware Installation Manual 68 Document #: LTRT-41441
7. (Hot-Swap Only) Software-insert the module, using the device's Web interface:
a. Access the device's Web interface.
b. Open the page with the graphical display of the device.
c. Click the title of the module ("<module name> Reserved") that you want to insert;
the Insert Module button appears:
d. Click the Insert Module button; a message appears informing you that the
module is currently being software-inserted. When the message disappears, the
module is inserted, indicated by the disappearance of the word "Reserved" from
the module's title.
8. For non-hot swappable module replacement only, power up the device.
6.2.2 OSN Server Modules
This section describes how to install and replace the OSN server modules (OSN and
HDMX).
6.2.2.1 Replacing Blank-Panel Slot Covers with OSN Server Modules
The procedure below describes how to install an OSN server module into a slot that is
currently not used (unoccupied) and covered by a blank panel.
Notes:
• Make sure that you install the HDMX module before you install the OSN module.
• The OSN server modules are hot-swappable and can be replaced without powering
down the device and thus, without disrupting other non-related OSN services (e.g.,
Gateway and/or SBC functionality) running on the device.
To replace blank-panel slot covers with OSN server modules:
1. Remove the new OSN server modules from their ESD shielding packets in which they
were shipped.
2. Install the HDMX Module:
a. Remove the blank-panel slot cover from the slot intended for the HDMX module,
by gently pulling on the handle of the module until it slides out of the slot.
b. Hold the HDMX module in the correct orientation, as shown in the figure below,
and gently insert the module into the slot, sliding it along the slot's guide rails until
it makes contact with the card-edge connector located on the backplane.
To Next Page
Loading...
