AudioCodes Mediant 1000B - 6 Hardware Maintenance; Chassis Slot Assignment for Modules; Front-Panel Module Slot Assignment; Figure 6-1: Chassis Front-Panel Slot Assignment for Modules

Hardware Installation Manual 6. Hardware Maintenance
Media Gateways & SBCs 61 Mediant 1000B Gateway & E-SBC
6 Hardware Maintenance
The device is a modular chassis and allows you to order any module as a Field
Replacement Unit (FRU). This section describes the procedures for installing or replacing
modules.
Warning: To prevent static electrical damage to the module's printed circuit board, do
not touch the components on the module. Instead, hold the module only on the edges
where no electrical components are located.
Avertissement: Pour prévenir des dégâts d’électricité statique au circuit imprimé du
module, ne touchez pas les composants sur le module. A la place, tenez le module par
ses extrémités où il n’y a pas de composants électriques.
Warning: Cover all unoccupied module slots with blank panels. This ensures optimal
internal airflow pressure within the chassis.
6.1 Chassis Slot Assignment for Modules
This section describes the chassis' slot assignment for the different modules.
6.1.1 Front-Panel Module Slot Assignment
The figure below displays the chassis' slot assignment on the front panel for the different
modules:
Figure 6-1: Chassis Front-Panel Slot Assignment for Modules
Please adhere to the following guidelines for slot assignment of these modules:

TRUNKS (PRI), BRI, FXS, and FXO Modules:
• The modules can be housed only in slots 1, 2, 3, 4, 5 and 6.
• The modules must be housed in consecutive slots. In other words, if the device
houses three modules, they must occupy slots 1, 2, and 3 (no skipping of slots).