Mediant 1000B Gateway & E-SBC
Hardware Installation Manual 72 Document #: LTRT-41441
6.2.3 Replacing the Fan Tray Module
The procedure below describes how to replace the Fan Tray module.
Warnings:
• DO NOT operate the device without the Fan Tray module.
• Before replacing the Fan Tray module, make sure that you have the replacement Fan
Tray module on hand so that you can immediately replace the failed module with it.
• When removing the Fan Tray module, the blades may still be rotating at high speeds
(even after the device has recently been switched off). Therefore, partially extract the
module from the chassis and then wait a few seconds to allow the blades to stop,
prior to extracting the module entirely from the chassis.
To replace the Fan Tray module:
1. Remove the faulty Fan Tray module:
a. Locate the two captive screws on the front panel of the Fan Tray module.
Figure 6-17: Captive Screws of Fan Tray Module
b. Loosen the two screws using your fingers or a flat-head screwdriver.
c. Grip and pull the two screws of the Fan Tray module to gently slide the module
out of the chassis slot.
To Next Page
Loading...
