Hardware Installation Manual 4. Mounting the Device
Media Gateways & SBCs 29 Mediant 1000B Gateway & E-SBC
4 Mounting the Device
The device can be mounted in one of the following ways:
Placed on a desk top (see Section 'Desktop Mounting' on page 29)
Installed in a standard 19-inch rack (see Section ‘19-inch Rack Mounting' on page 30)
4.1 Desktop Mounting
The device can be mounted on a desktop by attaching the four anti-slide bumpers
(supplied) to the underside of the device. Once you have attached these bumpers, simply
place it on a desktop in the desired position.
To attach the anti-slide rubber bumpers to the device:
1. Flip the device over so that its underside faces up.
2. Locate the four anti-slide grooves on the underside -- one on each of the four corners.
Figure 4-1: Location of Grooves for Rubber Feet
3. Peel off the adhesive, anti-slide rubber feet and stick one in each anti-slide groove.
4. Flip the device over again so that it rests on its underside and place it in the required
position on a desktop.
To Next Page
Loading...
